The Traffic Accident Reconstruction Origin -ARnews-

Re: crush damage measurement

theodore post (theodore832@qtm.net)
Sun, 22 Dec 1996 09:54:33 -0500 (EST)

Another way to build a jig is to take PVC water pipe. You then use O rings between the interconnecting pieces to hold them together and move them. The use the pipe T's for where the axle meets the length measurement. You can make the whole thing for $20 and it will fit in the trunk of your car.

theodore post
theodore832@qtm.net

NOTE: You are reading in an archived session of ARnews. It is possible that this topic is still being discussed. To see if this topic is still active, or of there were any more recent posts on this topic, check later archives of ARnews.

If there is no current post, and you would like to add to this topic, link to the Current ARnews Discussion and begin a new thread. Be sure that if you are starting a new post that the thread title does not contain the abbreviation RE: Placing RE: at the beginning of a new post will confuse Hypermail and prevent others from answering your post in the future.

For example, to continue this discussion look for a thread titled

crush damage measurement

If this thread does not exist in the current archive, you can begin another one by using that title.