The Traffic Accident Reconstruction Origin -ARnews-


Coefficient of Friction on Brick Street

Dan Patz ([email protected])
Sat, 21 Nov 1998 13:45:58 -0500 (EST)

I have a case involving a low-speed rear-end collision on a brick street. No information in the NUTI books. The situation was a heavily traveled brick street just outside downtown Dallas, no rain in Texas for months. Hot weather. Lawn sprinklers from an adjacent building have the street wet, but probably not cleared of the oil, dirt, etc. This isn't a serious enough problem to try to close down the street do a test, but I'd like a ballpark figure. I know brick streets get VERY slippery, but the question is HOW slippery? What would be a reasonable coefficient of friction to use in this instance? Hard to find in the literature.... Thanks for any info you might be able to provide!

Dan
Dan Patz
[email protected]


NOTE: You are reading in an archived session of ARnews. It is possible that this topic is still being discussed. To see if this topic is still active, or of there were any more recent posts on this topic, check later archives of ARnews.

If there is no current post, and you would like to add to this topic, link to the Current ARnews Discussion and begin a new thread. Be sure that if you are starting a new post that the thread title does not contain the abbreviation RE: Placing RE: at the beginning of a new post will confuse Hypermail and prevent others from answering your post in the future.

For example, to continue this discussion look for a thread titled

Coefficient of Friction on Brick Street

If this thread does not exist in the current archive, you can begin another one by using that title.