The Traffic Accident Reconstruction Origin -ARnews-

Re: AutoSketch Version 5.0

Ray Filer ([email protected])
Sat, 27 Mar 1999 10:57:31 -0500 (EST)

Tom
Have you found something to your liking??

After using AutoSketch 2.1 the past years. I was looking to upgrade
to keep up with progress. Purchased new laptop tried to download
AutoSketch 2.1. Loaded fine,
Began drawing, decide to edit poll down menu when I pressed save
in the box appearing. An error has occurred in your program to keep
working anyway, click ignore and save your work in a new file. To
quit this program click close. You will lose information you entered
since your last save.
Ignore will not work. Close only works.
X this program as an illegal operation and will shut down.
If the problem persists, contact the program vendor.
Their are two buttons under that message 1 is close the other is details.
Details States
Sketch caused a general protection fault in module
Chips 98. DRV: at 0001:00007F39------------- more and more------
Registers: EAX = 00000000 CS=03lf ----- and so on------
Bytes at CS:eip
26 89 55 la 8e------- and so on------
Stack dump:
ceza00ce------- and so on------
1.Is there a way to make AutoSketch 2.1 and Release 6, work together,
with the so 2.1 lay out????
3.Is there a program smeller to 2.1 without going throw these problems.
4.Will Office 97,work with them?

Ray Filer
[email protected]

NOTE: You are reading in an archived session of ARnews. It is possible that this topic is still being discussed. To see if this topic is still active, or of there were any more recent posts on this topic, check later archives of ARnews.

If there is no current post, and you would like to add to this topic, link to the Current ARnews Discussion and begin a new thread. Be sure that if you are starting a new post that the thread title does not contain the abbreviation RE: Placing RE: at the beginning of a new post will confuse Hypermail and prevent others from answering your post in the future.

For example, to continue this discussion look for a thread titled

AutoSketch Version 5.0

If this thread does not exist in the current archive, you can begin another one by using that title.